Guide

Controlling Lights & Eye Patterns

Lighting in PropPal is three separate, deliberate actions rather than one combined control. Here's how they fit together, plus how eye patterns work.

Steps

1. 1

   Pick a color

   Choosing a color alone doesn't change anything on the prop yet. It just sets what the next action below will use.

2. 2

   Tap Set Color to hold it

   Applies the color you picked as a solid, steady light.

3. 3

   Tap Cycle Colors for motion

   Makes the lights continuously rotate through colors instead of holding one.

4. 4

   Tap Lights Off when you're done

   Turns the lights off entirely.

Eye Patterns

1. 1

   The gallery is matched to real hardware

   Each picture in the eye pattern picker was matched by hand against real props, so what you see should match what lights up.

2. 2

   A mismatch usually means a different model

   If a pattern doesn't match what's shown, your prop model may number its patterns differently than the one PropPal matched the picture against. This is a display mismatch, not a malfunction.